Flint/Steel custom standard height striker with custom engraving and brass-embedded bow-drill divot 2.4" x .375" x .75".

High-carbon steel rod is held in walnut holder with strong neodymium magnets. Finished with spar urethane. 

Note: due to the very strong magnets, the steel rod can be hard to remove. When reinstalling BE CERTAIN that the hole in rod is perfectly aligned with slightly raised magnet within the striker body and pressed "firmly" down so there is no gap between rod and striker body showing at either end of the striker.

*Fill in engraving information prior to checkout, or shipping will be delayed since I would then need to contact you for that information.

*Requires 5-7 days processing time, due to engraving and other custom features,   before shipping

*NOTE that the maximum of "in stock" count may be only 2-3 since these are custom, and built when ordered which takes a while. When current stock has been depleted, and once the current orders are ready to ship, the stock status will go back to 2-3 until those ones are ordered, and the cycle repeats.

Short video showing use of bow drill divot: HERE

If "out of stock", request one be made for you ASAP: HERE

If during checkout you find shipping is not available to your country, please let us know: HERE

Some technical information: All striker rods make use of O1 steel, chosen for it's composition. The O1 steel for the rods has been normalized, then heat-treated in a way to maintain the fairly unstable martensite, then somewhat tempered for a result which produces optimum sparks while slightly reducing some of the brittleness which would otherwise be present. As a result of the quenching, the face-centered cubic austenite transforms to a highly strained body-centered tetragonal form which is supersaturated with carbon.